Smart Window (M) Sdn Bhd - Ultimate Cooling Solution


  • HOME
  • PRODUCTS
  • CARES & MAINTENANCE
  • CONTACT US

CARES AND MAINTENANCE OF YOUR NEW WINDOW FILM



CARES AND MAINTENANCE TIPS



PLEASE BE ADVISED THAT YOUR WINDOW FILM IS MOUNTED TO THE INTERIOR SURFACE OF GLASS AND SPECIFIC CARE INSTRUCTIONS ARE INTENDED FOR INTERIOR SURFACES ONLY.



Drying





Do not clean the coat surface for at least 7 days for automotive applications and 30 days for all other applications after the coating. This is to ensure that the adhesive completely bonds to the window. Do not roll your tinted windows down until dry!



cleaning





Window film may be cleaned with a sol\ft clean cloth and alcohol based cleaner or plain water. Ammonia products should not be used. A clean soft cloth or high quality paper towel is recommended for cleaning the window tint, followed by another clean soft cloth or soft rubber squeegee for drying. Do not use abrasive materials to clean your film. Avoid using bristle brushes, abrasive scrubbing sponges or any other cleaning materials that could scratch the film.



Stickers





Put stickers someplace else. Never use adhesives or suction cups to put anything on your tinted car windows. Leave the bumper stickers for your bumper.



Chips





Take care when loading boxes and other items into your car. Hitting the tinted window will cause nicks. Caution should be used when releasing seat belts. Small chips can be made in the window film due to the seat belt hitting the glass as it is released. THIS IS NOT COVERED BY WARRANTY.



peeling





Most cars have a black ceramic "frit" edge on the rear window. sometimes this ceramic edge is straight and flat, sometimes it will have a dotted edge. These black ceramic dots are quite thick on most cars and prevent the window film from sticking to the area between the dots. DO NOT PICK THE EDGES OF THE COATING. This may cause delaminating or peeling.



bubbles and cloudy look





Our authorized dealer will install your window film using a specially formulated mounting solution. During the installation process, they will remove as much of the mounting solution as possible although a small amount will remain. Trapped installation moisture can cause small water bubbles and/or a slightly cloudy look, this is normal and should be expected and can take up to 4 to 10 weeks to completely dry out. Do not attempt to pierce a water bubble during the drying period. Water bubbles and cloudy look will eventually dissipate. Attempting to pierce a water bubble in an effort to drain moisture will damage your film.



demister - rws





Do not switch on the rear screen demister for at least 2 weeks after the installation.



Smart Window (M) Sdn Bhd



No. 15-G, 15-1, Jalan Perubatan 2, Pandan Indah, 55100 Kuala Lumpur, Malaysia.
smartwindow@hotmail.com